The Pharma-X is a compact point-of-use cooler for Water-For-Injection (WFI) or Purified Water (PW) systems.     Easy to install module The Pharma-X point-of-use cooler is based on an innovative tube-in-tube heat exchanger. For quick and easy installation, the Pharma-X is suppleid as a complete insulated module with a pitot tube arrangement and either manual or automatic valves. Installed in a water system, the Pharma-X module can be regarded as a sub-loop of the main loop. Hygienic design The Pharma-X meets the stringent hygienic standard imposed by both control authorities and industry. All product wetted parts in the Pharma-X are electropolished and the tubes as seamless. No risk of cross-contamination There are no internal welds in the Pharma-X, thereby eliminating the risk of cross contamination between the product and the service medium. Drainable The Pharma-X is fully drainable on the product side, with no dead legs. Quick response When switching from 'stand-by mode' to 'cooling mode', cold water is available within seconds. Efficient The low hold up volume and the quick response of the heat exchanger ensures that waste of WFI or PW is minimized. The cooling water demand is very low thanks to the efficient heat transfer. SIP If needed, the Pharma-X can be steam sterilized. Minimum maintenance The Pharma-X is virtually maintenance free with no internal gaskets. Standard sizes The Pharma-X is available in six standard sizes with a heat transfer area ranging from 0.3 m2 to 1.0 m2, allowing a flow rate up to 1800 l/h.